Installing the Ram^® Mount Cup Holder with a Double Socket Arm to a SeaMount^® Base Plate on your paddle board

Kit Contains:

1 Base Plate

1 Screw

1 1” Ram® Tough Ball 1/4X20

1 Ram® Mount Cup holder with a Double Socket Arm

Step 1: Lightly Spray the Base Plate screw with lubricating oil, like WD-40 on first use and a couple times a season after that.

Step 2: Place the Base Plate over a SeaMount^® where the Base Plate lays flat on the paddle board.

Step 3: Use a phillips head screwdriver to screw the Base Plate into the SeaMount^®. Do not overtighten.

Step 4: Hand screw the 1” Ram^® Tough Ball into the 1/4X20 threading on the Base Plate.

Step 5: Twist the knob on the Double Socket Arm counter clockwise to loosen/open and attach to the 1” Ram^® Tough Ball.

Step 6: Twist the knob on the Double Socket Arm clockwise to secure it to the 1” Ram^® Tough Ball.

Step 7: Adjust the knob to get the desired position of the Cup Holder and tighten.

Step 8: Remove the Cup Holder, Tough Ball and Base Plate when traveling or transporting your SUP board.

Step 9: Rinse paddle board and accessories with freshwater if used in saltwater.