A video guide to installing the Ram® Mount Cup Holder with a Double Socket Arm to a SeaMount® Base Plate
From the Pau Hana SUP School
KIT CONTAINS:
1 Base Plate
1 Screw
1 1” Ram® Tough Ball 1/4X20
1 Ram® Mount Cup holder with a Double Socket Arm
INSTRUCTIONS:
- Lightly Spray the Base Plate screw with lubricating oil, like WD-40 on first use and a couple times a season after that.
- Place the Base Plate over a SeaMount® where the Base Plate lays flat on the paddle board.
- Use a phillips head screwdriver to screw the Base Plate into the SeaMount®. Do not overtighten.
- Hand screw the 1” Ram® Tough Ball into the 1/4X20 threading on the Base Plate.
- Twist the knob on the Double Socket Arm counter clockwise to loosen/open and attach to the 1” Ram® Tough Ball.
- Twist the knob on the Double Socket Arm clockwise to secure it to the 1” Ram® Tough Ball.
- Adjust the knob to get the desired position of the Cup Holder and tighten.
- Remove the Cup Holder, Tough Ball and Base Plate when traveling or transporting your SUP board.
- Rinse paddle board and accessories with freshwater if used in saltwater.
To purchase the Ram® Mount Cup Holder and Double Sockert Arm CLICK HERE.
