A Video Guide to Installing the Ram® Mount Revolution JR Rod Holder to a YakAttack Slider on your paddle board
From the Pau Hana SUP School
KIT CONTAINS:
1 YakAttack Slider
2 Screws
1 1.5” Ram® Sliding Tough Ball
1 Ram® Mount Revolution JR Rod Holder or Ram® Tube Rocket Launcher
INSTRUCTIONS:
- Lightly Spray screws with lubricating oil, like WD-40 on first use and a couple times a season after that.
- Line up the the YakAttack Slider over two SeaMounts® that are 10”-12” apart on your paddle board.
- Use a phillips head screwdriver to screw the screws into the SeaMounts®.
- Step 4: Loosen the slider on the 1.5” Ram® Sliding Tough Ball counter clockwise to slide into the track.
- Tighten the 1.5” Ram® Sliding Tough Ball clockwise in the track in the position desired.
- Twist the knob on the Socket Arm counter clockwise to loosen/open and attach to the 1.5” Ram® Sliding Tough Ball.
- Twist the knob on the Socket Arm clockwise to secure it to the 1.5” Ram® Sliding Tough Ball.
- Adjust the top knob to twist the Ram® Mount JR Revolution Rod Holder in the direction you desire.
- Remove the Rod Holder, Tough Ball and Slider when traveling or transporting your SUP board.
- Rinse paddle board and accessories with freshwater if used in saltwater.
To purchase the Ram® Revolution Rod Holder CLICK HERE.
